JMP Battery Charger Skan 4.0 CAN-Bus   Microprocessor-controlled high-tech battery charger of the latest generation with 8 charging stages. Suitable for both quick charging of a battery and long-term maintenance charging, e.g., during vehicle winter storage.   Suitable for: Standard Lead AcidGelAGMEFBLithium (LiFePO4)   Technical Data: 12 V /1 - 4 Afor batteries from 4 Ah to 120 AhLow voltage detection: 0.7 VOvercharge protection, reverse polarity protectionSplash and dust proof (IP65)Dimensions: 190 x 80 x 50 mmWeight: 0.75 kgPower cable: 2 mConnection cable: 2.10 m   Scope of delivery: 1x JMP Skan 4.01x Adapter cable with clamps1x Adapter cable with ring terminals for permanent connection to the battery1x Adapter cable for onboard socket (CAN-Bus)            

Fully insulated bike battery disconnect switch for disconnecting the onboard network to preventdeep discharge of the battery due to constant consumers like clock, onboard computer,accessories, etc. during longer standstill periods.Disconnection is achieved simply by loosening the screw.Just loosen the screw by 1-2 turns and leave it in the switch. This way, it cannot be lost.For driving operation, please tighten it properly. Mini designFully insulated housingFlexible mounting between negative terminal and vehicle Load max. 160A - 12V / 10 sec. then pause for 30 sec.Bridge cable included.Installation instructions on product insert Dimensions:L / W / H: 62 x 25 x 38 mmCable: 200 mm

Battery terminal distributor to simplify hard-to-reach connection work on the motorcycle battery. Simply connect to both terminals, and in the future, additional consumers such as navigation devices or sockets for mobile phone chargers can be easily connected.   -Protected connections -Easy installation -Fuse for + lead included - Length: 10 cm    

JMP Skan Monitor 2 Battery monitoring with your smartphone   “Not suitable for lithium batteries.”   With the JMP Skan Monitor 2 and the new free Apple or Android app “JMP BatteryMonitor II”, you can quickly and easily check the charge status of your battery. Only with a consistent, positive charge status of the battery is the full capacity and usability guaranteed.   The positive charge status also prevents potential early damage or failure of the battery. Through continuous recording, the charge status of the battery is captured during rides and can be accessed later. The file with the data can be sent via email from the smartphone and displayed in Excel. This allows you to quickly identify where the charging voltage dropped or was too high. A defective regulator can be quickly recognized.   Additionally, with the new app, starting processes (starter, cable connections, etc.) and charging processes (alternator, cables, etc.) can be accurately checked. This saves long troubleshooting in case of problems. In case of low battery status or other issues, a notification can warn the rider depending on the settings in the app options. After simple connection using eyelets to the battery and downloading the new Android or Apple app, the current voltage value can be retrieved.   The transmitter is suitable for 12 V batteries.The range is approximately 10 meters.The connection is made via Bluetooth. (Only from Bluetooth 4.0; e.g., from iPhone 4s, iPad3, or iPod Touch 5)   The JMP Skan Monitor 2 is excellent for detecting overvoltage > 14.9 V from the alternator before damage to the battery occurs.   Please note: The new JMP Skan Monitor 2 requires the new app “JMP BatteryMonitor II”! If the minimum voltage is not met, a reminder to recharge the battery soon will be issued.- Easy attachment using eyelets to the battery- Power consumption only about 2 mA- No damage to the transmitter or battery occurs in case of reverse polarity- Free app available for download in the Apple App Store or Google Play Store under JMP Battery Monitor II- Voltage recording also during the ride. Results can be sent via email. File display in Excel is possible.